Forehead Bandage: Typical Use – Lacerations

Step 1:
Make sure you’re practicing proper BSI procedures.
Place a 4x4
gauze onto the injury, or better yet, get the
patient
to do it!

Step 2:
Make a “Tail” on the roller gauze so the bandage
can be secured
and won’t come undone.

Step 3:
Wrap around the “Tail” on the first pass and fold
over the
“Tail” after the first pass. Make sure you go low
over the
base of the skull.

Step 4:
After the first pass, bend the tail back.

Step 5:
Tail bent back.

Step 6: Use
half twists of the roller gauze to insure the
bandage
is tight and conforms to the contours of the scalp.

Step 7:
Fully cover the bent back tail on subsequent
passes.
Be careful to keep the bandage out of the eyes
of the
patient.

Step 8:
Most head bandages are going to require two
roller
bandages to complete effectively. When you run out
of the
first roller bandage, get a second one and re-start
making yet another tail..

Step 9:
Start a new roller gauze tail.

Step 10: Don’t
be afraid to ask the patient for their help in
stabilizing
the bandage.

Step 11:
Pull up the tail after the first pass of the second
gauze
wrap.

Step 12: ON
the next pass which would cover the tail, start
down
under the chin and come back up over the head.
This will
fully secure the bandage in place.

Step 13:
Come over the top of the head and go back under
the chin,
taking care to not obstruct the windpipe.

Step 14:
Under most circumstances, your patient should
remove any
eyewear they would have on, but in this case
our
patient was a “reluctant” contributor. ;-)

Step 15:
Don’t forget to periodically do half twists of the
roller
bandage to secure it to the contours of the head.

Step 16:
Unroll the remainder of the bandage and loop it
down
under the patient’s chin and tie it off on the top of
the head.
If the patient has a hat, replace the hat on top
of their
head.

Completed bandage.

Completed
Bandage – Note bandageis not in the patient’s
eyes.

Creating
bandages of this nature hold the original dressing
on the forehead in place.